Chipboard Ornament
|
CASEd from Jana Weaver Ink
Cardstock/Paper
Accessories
|
|
| (back view) |
|
Step 1Choose a chipboard ornament and pop out the center shape. |
|
Step 2Ink one side of the ornament (not the center piece) with Real Red craft ink. |
|
Step 3Heat set the ink using an embossing gun. |
|
Step 4Trace the ornament onto a piece of Dashing DSP. Cut out. |
|
|
|
Step 5Glue the paper onto the backside of the ornament. |
|
Step 6Ink the shape with Real Red craft ink. |
|
Step 7Pour on iridescent ice embossing powder and melt with the embossing gun. |
|
Step 8Once the shape has cooled, rub VersaMark all over. |
|
Step 9Pour on glassy glaze embossing powder and melt with the heat gun. |
|
Step 10Repeat steps 8 and 9 to get 2 coats of glassy glaze embossing powder. Make sure the surface is nice and smooth. |
|
Step 11Adhere the shape to the back of the ornament. Try to line up the shape with cutout on the front. The best way to do this is to hold the ornament up to the light. |
|
Step 12Use the crop-o-dile to punch 2 holes near the edge or the ornament. |
|
Step 13Thread grosgrain ribbon through the holes and tie a bow on the side that has the embossed shaped. This is the front of the ornament. |
|
Step 14Thread some elastic cord through the top hole and tie a knot at the end to form a loop. Your ornament is ready to hang on the tree! |
|
